All About Sewing Knitting and Crochet, Patterns and much more

This machine comes with an attachment for spools that are too big, however, they are even too big for that. = (

My question is, is there a way to get the large spools of thread wound onto a smaller spool that fits into my machine?

Thank you so much for your help!!!!
I don't know about returning the spools but I can probably re-sell them.

So...you're saying I can put a bobbin in the top of the machine where a larger spool normally goes? I never knew you could do that.
My bobbin winder is a little odd. It's a cheap plastic piece that lays down, I have to stand it up and it's too weak to hold the larger spools. ha ha

But if it's safe to wind it by hand, I'll try that. I was afraid if I did a bad wind job it might jam my new machine.